Three Falling Sand Experiments to Try

Open the sandbox to try three experiments. Load a preset for the first two, or choose Clear and build your own layered cup.

1. Make a leaky dam

  1. Open the sandbox, select Start sandbox, then choose More → Leaky dam below the canvas. A cup of water loads paused, with a gap low on its right wall.
  2. Select Resume. The water drops, spreads along the floor and begins to escape through the gap. Press Pause to inspect where it collects.
  3. Select Leaky dam again to reset the same starting setup. Before resuming, use Wall with a small brush to close the gap. Compare how much water gets out with the gap open and closed. You can also use Erase to widen it and try again.

Use More → Demo to restore the terraced basin. The setup is part of this browser sandbox and models water as moving cells.

2. Compare sand and water

Run the side-by-side sand and water simulator to open the prepared scene directly.

  1. In the sandbox, choose More → Sand vs. water. You start paused with equal amounts of sand and water, in separate cups of the same width.
  2. Select Resume. As the cells settle, sand forms a sloped pile on the left. Water spreads farther along the floor on the right. Pause when both shapes are visible.
  3. Choose More → Sand vs. water again to repeat the comparison. Try adding a wall on the right before you resume and see how it changes the water's path.

The comparison shows this game's grid rules. Sand can fall and slide diagonally. Water can also move sideways when it reaches the floor.

3. Build a layered cup

Draw a walled cup with an open top. Add water, then sprinkle sand above the cup. Watch the sand cells move through the water. Pause after the first few grains collect if you want to inspect the change before it settles.

For keyboard brush controls, see How to play. Reloading the game starts a fresh scene.

Try the daily sand challenge for a new dam setup with a measured result.